Futaba 6EXAP 6-Channel FM 40MHz/ R136F  [6EXAP_c2]

CHARACTERISTICS:

• Aileron, Elevator and Rudder double price switch - employ this change to flip between two aileron, elevator and rudder control throw settings. The tosses could possibly be setup but choose, but generally, whenever switch is up the throws are greater (high rate) once the switch is down the throws are less (low rate). This switch additionally flips between exponential costs (if utilized).
• Flap control dial/Channel 6 - This dial runs the servo attached with channel 6 to the receiver when your model has flaps this is actually the control accustomed operate them.Aileron/elevator control stick -Mounting point for optional throat band.
• Trim levers (all) -Used to go the basic or center host to each servo as labeled in diagram.
• Recharging jack - Port for recharging the transmitter batteries aided by the included battery pack charger.
• On-off switch
• DATA INPUT lever - regularly replace the values of this different functions presented in the LCD screen.
• Liquid-crystal display (LCD) - shows development modes and values entered.
• MODE key - accustomed scroll through and show the ten or eleven(PCM) different functions.
• CHOOSE key - always display the values the current function.
• Throttle-cut switch - to utilize the throttle-cut function, lower the throttle stick all the way, then drive the throttle-cut switch to completely shut the carburetor and shut associated with the motor.
• Throttle/rudder control stick - Operates the servos attached to channel 3 (throttle) and channel 4 (rudder) in receiver.
• Trainer switch - runs the trainer functions. To use as a trainer switch the transmitter must certanly be connected to another transmitter via. a trainer cable (available independently).
• Retractable landing gear switch/Channel 5 - change operates the servo linked to channel 5 inside receiver in the event that model has retractable landing gear this could be the control always expand and retract the apparatus.
• Antenna - Radiates signals on receiver. Never ever travel a model without completely expanding the antenna or perhaps you'll produce disruption along with other modelers and decrease operational signal array of the
• transmitter. The antenna might removed and replaced with another in the event its unintentionally broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Handbook

SPECS:

Transmitter

• T6EXAP Transmitter with programmable mixing and 6-model memory.
• Transmitting on 40 / 72 MHz musical organization.
• Operating-system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power: 9.6V NT8S600B Ni-Cd battery or 12V alkaline battery pack
• Present drain: 250mA

Receiver

• R136F narrow musical organization, FM 6 channel receiver.
• Receiving on 40 / 72 MHz musical organization.
• Type: FM, Dual conversion/FM, solitary conversion
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Power requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• Weight 0.98oz (27.8g)