Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003  [6EXAP_c7]

Price:
AUD$302.38
Brand:
Futaba
Model:
6EXAP_c7
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category
Write a review
QUALITIES:
  • Aileron, Elevator and Rudder double cost switch - use this change to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses is create nevertheless choose, but generally speaking, whenever switch is ��up�� the throws are greater (��high rate��) as soon as the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential rates (if utilized).
  • Flap control dial/Channel 6 - This dial runs the servo mounted on channel 6 to the receiver when your model has flaps this is actually the control used to run them.Aileron/elevator control stick -Mounting point for optional neck strap.
  • Trim levers (all) -Used to go the essential or center place of every servo as labeled within the diagram.
  • Recharging jack - Port for recharging the transmitter batteries aided by the included battery pack charger.
  • On-off switch
  • INFORMATION INPUT lever - accustomed replace the values of the various functions shown about the LCD display screen.
  • Liquid-crystal display (LCD) - shows development modes and values joined.
  • MODE key - constantly scroll through and show the ten or eleven(PCM) different functions.
  • PICK key - constantly reveal the values the present function.
  • Throttle-cut key - to utilize the throttle-cut function, lower the throttle stick completely, then drive the throttle-cut key to fully shut the carburetor and shut of motor.
  • Throttle/rudder control stick - operates the servos attached to channel 3 (throttle) and channel 4 (rudder) inside the receiver.
  • Trainer switch - Operates the trainer functions. To get results as a trainer switch the transmitter should be linked to another transmitter via. a trainer cable (available separately).
  • Retractable landing gear switch/Channel 5 - Switch runs the servo connected to channel 5 inside receiver in the event your model has retractable landing gear this is actually the control always extend and retract the apparatus.
  • Antenna - Radiates signals to the receiver. Never ever travel a model without fully expanding the antenna or maybe you might produce disturbance to many other modelers and decrease functional signal array of the transmitter. The antenna could be removed and changed with another in case its inadvertently broken.

Copyright © 2008-2024 rcjaz.com.au All rights reserved


Merry Deals for Every Hobbyist!
Redeem [ XM03 ] for 3% OFF—no minimum required!
Use [ XM05 ] for 5% OFF on orders over $100!
Go big with [ XM10 ] for 10% OFF on orders over $200!
This Christmas, gift your hobby the savings it deserves!